slidingsky

I was just wondering if two t3s could feed a street ported 13bt? They seeem really cheap, have internal wastegates. The manifold, intercooler, and exhaust wouldnt be a big concern. Im aiming at about 400hp. What else could do the job at under $500 a peice. Ive seen alot of t3s on ebay for under $300. Again Im just kickin ideas around.
sky

Aaron Cake

iTrader: (1)

T3 is way too small. It's a little smaller than the stock turbo.

slidingsky

so they are too small even if i use two?

Aaron Cake

iTrader: (1)

Well I guess if you use two it'll work, but why not just put a single larger turbo on? TO4s are common, and not very laggy.

Ryde _Or_Die

I'm no expert on turbos so you'd have to ask around to see if these are good for your application:

http://cgi.ebay.com/ebaymotors/ws/eB...tem=1873281507

http://cgi.ebay.com/ebaymotors/ws/eB...tem=1873564573

http://cgi.ebay.com/ebaymotors/ws/eB...tem=1873815538

http://cgi.ebay.com/ebaymotors/ws/eB...tem=1873884732

http://cgi.ebay.com/ebaymotors/ws/eB...tem=1873752306

No7Yet

I've thought about running two T3 turbos, with one each per rotor, but I think that they would be too big (and thus laggy) - consider boost response on a typical T3-equipped Honda, then remember how comparatively little air a single rotor flows at low RPM.

In any case, you'd be in for a lot of very custom work.

Brandon

hawk 7

iTrader: (2)

Why not just have the stock turbo rebuilt by Bryan at BNR.


BNR SUPERCARS