I finally got around to placing my T2 JDM Engine in my N/A car, and the tranny mounts aren't lining up. What can be done? Is there a common part that you can buy? Do I have to fabricate something? What has everyone else have done? I thought this was a common swap.

 

Tranny mounts where?

A trans crossmember mount must be the same series as the transmission. It should not matter Turbo or N/A.

 

plus 1
I put s/4 t2 trans in my s/4 na car.

 

Did the car have an auto tranmission in it?

 

when i swapped my turbo II setup(engine and tranny with tranny mount) into my n/a i had to grind the bolt holes a little bigger but i dont know if a n/a mount on a turbo transmission will work with a n/a mount

 

The car was a N/A auto tranny, and I have a T2 Tr engine and tranny that isn't lining up.

 

Auto trans mounted in different locations, you will need to make your own or find a mount adapter.

 

Where can I get a tranny mount adapter?

 

http://www.rotaryresurrection.com/2n...to_5speed.html

 

^ Which says fabricate a mount...