2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

stereo sizing ?s

Thread Tools
 
Search this Thread
 
Old Jul 29, 2003 | 09:04 PM
  #1  
sectachrome's Avatar
Thread Starter
pistons=teh suck
Tenured Member 05 Years
 
Joined: May 2003
Posts: 933
Likes: 0
From: NJ
stereo sizing ?s

will most new aftermarket head units fit in the factory cutout? will this work? also what are the sizes of the rear and dash speakers? is there anything to watch out for when picking out this stuff that might not work with the car? thanks as always!
Reply
Old Jul 29, 2003 | 09:08 PM
  #2  
Project84's Avatar
Open up! Search Warrant!
Tenured Member 05 Years
 
Joined: May 2002
Posts: 3,838
Likes: 3
From: Kicking down doors in a neighborhood near you
All aftermarket head units should fit width wise. The height of the factory stereo is twice as tall as the aftermarket ones. You will need something to fill the space that will be above or below the new stereo.
Reply
Old Jul 29, 2003 | 09:16 PM
  #3  
sectachrome's Avatar
Thread Starter
pistons=teh suck
Tenured Member 05 Years
 
Joined: May 2003
Posts: 933
Likes: 0
From: NJ
well the previous owner replaced it with a sony tape deck which is now a peice of ****, hence the replacing, so i guess i kinda answered my own question there. but it looks like he had to cut top part of the plastic frame out to make it fit (height wise).
Reply
Old Jul 30, 2003 | 12:30 AM
  #4  
sectachrome's Avatar
Thread Starter
pistons=teh suck
Tenured Member 05 Years
 
Joined: May 2003
Posts: 933
Likes: 0
From: NJ
bump
Reply
Old Jul 30, 2003 | 12:48 AM
  #5  
Driv300mph's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Jun 2003
Posts: 293
Likes: 0
From: Oklahoma
well, it should work, I have one in mine -- look at my interior page on my website to see -- I'm almost positive that it's the same size as stock.
Reply
Old Jul 30, 2003 | 12:46 PM
  #6  
sectachrome's Avatar
Thread Starter
pistons=teh suck
Tenured Member 05 Years
 
Joined: May 2003
Posts: 933
Likes: 0
From: NJ
what are the speaker sizes??
Reply
Old Jul 30, 2003 | 03:03 PM
  #7  
ilike2eatricers's Avatar
I R SAD PANDA W/O BAW
 
Joined: Nov 2002
Posts: 6,061
Likes: 1
From: bay area
you can fit 6.5 in the front and rear. I just did a full infinity system in mine. For the front you will need the spacers to clear part of the inside of the door/window track and the rear the spacer will only be able to be screwed on 2 points not all three. These are my experience with the infinity speakers only, I cannot speak for other speakers.
Reply
Old Jul 30, 2003 | 03:09 PM
  #8  
$100T2's Avatar
On the prowl for an FB
Tenured Member 15 Years
iTrader: (1)
 
Joined: Sep 2002
Posts: 2,932
Likes: 6
From: Surrounded by Sebey parts, Rhode Island
If you are replacing the speakers in the dash, you are going to have a tough time... Most decent aftermarket speakers are too deep to fit, and you won't be able to install it on the drivers side. The speaker under the glove box is pretty straightforward though.

As far as your head unit goes, yes, it will fit. Depending on the previous owner's hack job, you will either need a new install kit or possibly a new dash surround... Depends what/how it was cut.

Also, look for a head unit on ebay... You can get something nicer than that crutchfield pioneer for the same money.
Reply
Old Jul 31, 2003 | 01:52 AM
  #9  
Full Member
Tenured Member 10 Years
 
Joined: Jul 2003
Posts: 126
Likes: 0
From: Oregon
I have an 89 gtu. the deck requires a din and 1/2, you can pick up the spacer at any stereo store, it is something they keep on hand. this is what I have in my car. In the factory speaker position in the front dash, I have 2 kicker comp 4.5's I have infinity comps series 6.5's with rotatable tweat. in the back in the pods I have infinity 8's run them as woofers. then I also have 4 fosgate he2 10's directly behind the seat. the 4.5's are powered by a pioneer dehp 700 deck. the 6.5's are powered by infinity component amps. the 8's are powered by a rockford bd 500.2 the 10's are powered by a rockford bd100.a1 if you want the schematics I have the cad plans, and I can take pictures of the system as well. it hit's in the 160 range depending on how much they allow you to rev the engine.......
Reply
Old Jul 31, 2003 | 01:58 PM
  #10  
sectachrome's Avatar
Thread Starter
pistons=teh suck
Tenured Member 05 Years
 
Joined: May 2003
Posts: 933
Likes: 0
From: NJ
i dont have the door speakers, its an s4. i found this site, www.hookedontronics.com, that has everything real cheap. im not looking to make some crazy bumpin system, just something that sounds good. i was planning on that pioneer head unit, and infinity speakers in the dash and rear.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
Jul 17, 2019 02:20 PM
SakeBomb Garage
Vendor Classifieds
5
Aug 9, 2018 05:54 PM




All times are GMT -5. The time now is 12:00 PM.