2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

starting problem

Thread Tools
 
Search this Thread
 
Old Jun 9, 2003 | 12:23 PM
  #1  
rx-7fc's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 865
Likes: 0
From: oakland Ca
starting problem

my car is kind if hard to start if it you let it sit for around 3 hours or more and sometimes you have to hold the fuel line closed to start it or in the mourning when you try to start it too and is it flooding or low compression sometimes you can get it started and at first you would have to crank it for a few seconds then it would start and now it is doing what i said at the top
Reply
Old Jun 9, 2003 | 01:24 PM
  #2  
rx-7fc's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 865
Likes: 0
From: oakland Ca
can it be the injectors
Reply
Old Jun 9, 2003 | 01:33 PM
  #3  
jsotelo's Avatar
Full Member
Tenured Member 15 Years
 
Joined: Aug 2002
Posts: 237
Likes: 0
From: Elk Grove, Cali
If it only happens after a few hours sounds like it might be leaky injectors but I have never had this problem so..

anyway do a seach.. there is a switch you can make that will let you turn off your injectors so they won't flood.
Reply
Old Jun 9, 2003 | 01:43 PM
  #4  
rx-7fc's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 865
Likes: 0
From: oakland Ca
i did do a seach and did not find any thing so i posted it
Reply
Old Jun 9, 2003 | 02:14 PM
  #5  
jetfire76's Avatar
Gas Guzzlin' Tire Junkie
Tenured Member 15 Years
 
Joined: Aug 2002
Posts: 459
Likes: 0
From: 19805
try searching for "fuel cutoff switch"
Reply
Old Jun 9, 2003 | 02:18 PM
  #6  
HAILERS's Avatar
HAILERS
Tenured Member 10 Years
 
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
Try this https://www.rx7club.com/forum/showth...ircuit+opening

Look for the answer by NZconvertible

And or....look at the top of this very page. See just to the right of FAQ the word Search? Click it. THEN when the search page comes up, in the blank in left type FLOODING and then in the blank to the right write NZCONVERTIBLE. Now click to search. Read the nzconvertible answers.

Or... in the Search blank to the left write Circuit Opening and then to the right , write nzconvertible. Read the answers.

And be advised.....after i got thru running my 82 RX right into the ground, it started having starting problems. Low compression was the cause. It was easier to get that car working because I could just pour a half cup of motor oil in the carb and crank it up. Fuel injection makes this harder and too much of a bother.

Do make a fuel cut switch. But also take the other advice you'll find in the threads, such as injector cleaning etc. But then again, a worn out engine ain't a gonna start much better even with new injectors if the compression has gone.

Try these also: https://www.rx7club.com/forum/search...der=descending

And this shows how a Circuit Opening Relay works:
https://www.rx7club.com/forum/showth...62#post1854862

And if you need an online factory service manual, go here:http://www.iluvmyrx7.com
https://www.rx7club.com/forum/showth...hreadid=163732
http://www.teamfc3s.org

Last edited by HAILERS; Jun 9, 2003 at 02:29 PM.
Reply
Old Jun 9, 2003 | 02:35 PM
  #7  
HAILERS's Avatar
HAILERS
Tenured Member 10 Years
 
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
Or this: https://www.rx7club.com/forum/showth...light=fuel+cut

Another tack, is to write in the words BAND-AID in the left blank, and then nzconvertible in the right blank. Hmmm.

Or write in FLOODING in the left blank and ICEMARK in the right blank. Then you will get a list a mile long. Go for the first one. It's this one https://www.rx7club.com/forum/showth...hreadid=181219 and look down that list of FREQUENTLY ASK QUESTIONS ABOUT FC'S and there is one concerning .....your problem.

Last edited by HAILERS; Jun 9, 2003 at 02:42 PM.
Reply
Old Jun 9, 2003 | 03:10 PM
  #8  
rx-7fc's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 865
Likes: 0
From: oakland Ca
thanks HAILERS
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
1993fd3sracer1
3rd Generation Specific (1993-2002)
29
Oct 13, 2015 01:57 PM
1993fd3sracer1
1st Generation Specific (1979-1985)
20
Sep 7, 2015 11:50 AM




All times are GMT -5. The time now is 10:06 AM.