DC350

These are my modifications, do you think the FMIC would be a good upgrade?


4000km on rebuilt monster ported engine.
S-afc, (not very well tuned)
720 cc secondary injectors
3 inch downpipe
2.5 inch dual piping to high flow mufflers
high pressure oil pump
race bearings
turbonetics boost controller
racing beat dual underdrive pullies
walboro 255 lph fuel pump
no emmisions
taylor racing spark plug wires
FCD


Running 7-12psi..

What do you think about Starion FMIC's? good upgrade?

nonameo

yes.

jacobcartmill

iTrader: (6)

it sucks.

however its a better setup than the stock topmount.

-TAL-

A starion really isn't that cheap.

Spend the little bit extra and buy a better intercooler, the hardest part is piping it. If you want to do it cheaply, combine two stock top mounts, and front mount that.

The rx7 stock top mount intercooler is a good intercooler, but it's in a bad spot.

Rex4Life

Alot of your cost will be piping and connectors. Spend a little extra and put a quality intercooler on there. From what I've heard the Starion IC is not very good, I think most guys have gone with the NPR and seem happy with it.

I'd look around on the forum and research it. You'll also get a good idea of how others have piped/installed the IC--there are many options. I had my setup posted here but the mods moved it over to the first gen section--even though I'm running a S4 setup.

Good Luck,

Scott

rotarygod

iTrader: (1)

The Starion intercooler sucks. It looks larger than stock but there is a tradeoff. You are going to get a larger pressure drop through it. Look at how many rows there are through the core for air to flow through. Now compare this to the amount that the stock intercooler has. The stock one has more flow. The stock core also has fins within the cooler itself (called turbulators) that aid in heat transfer to the core. the Starion cooler doesn't have these. The Starion cooler may be larger so it appears it can cool better, but the added restriction will more than cancel it out if not make power worse. If you use 2 Strion cores welded together in parallel, you'd be fine but just 1 won't cut it in the flow department.