size of the restrictor in the turbo preasure pipe?
Thread Starter
Full Member
Joined: Mar 2003
Posts: 129
Likes: 0
From: Sweden
size of the restrictor in the turbo preasure pipe?
I lost my restrictor when I installed my booscontroller..
After install I could not hold a steady boost .. so i clamped the preasure pipe and got good boost ...
what is the dimension of the small restrictor in the pipe originaly ?
/bo
After install I could not hold a steady boost .. so i clamped the preasure pipe and got good boost ...
what is the dimension of the small restrictor in the pipe originaly ?
/bo
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
The hole is the size of a normal straight pin, like a taylor or seamstress would use.
It goes in the hose to the pressure sensor to keep boost spikes from giving fuel cuts.
It is normally completely seperate from the waste gate line.
The stock boost control works by bypassing pressure before the waste gate line.
An aftermarket boost controller normally goes in the waste gate line, just before the actuator.
It goes in the hose to the pressure sensor to keep boost spikes from giving fuel cuts.
It is normally completely seperate from the waste gate line.
The stock boost control works by bypassing pressure before the waste gate line.
An aftermarket boost controller normally goes in the waste gate line, just before the actuator.
Last edited by SureShot; Jul 12, 2004 at 09:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM