First of all I searched, but cant find what I'm looking for.

My friend had spare 240SXH&R spacers and they fit fine. The problem is...the studs. I know the thread is not the same. But can I use them anyway and just buy new lug nuts? Will they fit properly?

Another thing, in the FSM they tell you to use a press to get the studs out....I dont have one. Can I just use a hammer?


Thanks!

 

Ok wait, are these the type of spacers that have their own studs? If so then you don't need to press anything out, and yes, you can use different lugs, just be very careful not to mix them up.

You can use a hammer to get the studs in and out, just don't do it with the hubs on the car, it's bad for the bearings, and in the rear you can't get long studs in without taking off the hub anyway. Be sure to protect the studs by putting on a crappy old lug nut and hammering on it.