Ryan_13b

iTrader: (3)

So im working on a S5 t2 and it keeps going into limp mode and throwing a code for the OMP. So i have a few laying around the shop and swapped them out and it will drive fine for a couple miles then go into limp mode again. any ideas? wiring? bad ecu? maybe theres a fuse or relay i dont know about?

Thanks in advance,
Ryan

SpikeDerailed

iTrader: (7)

Bad OMP usually takes out ECU. Good chance both could be gone.

jackhild59

iTrader: (7)

Stop driving it as soon as you can. Your OMP is bad.

The code for the OMP automatically puts the ECU into limp mode. The only thing you can do is put in a known good OMP or have the ECU chipped with an Rtek chip which disables the OMP circuitry. BUt now you have to mix oil in your gas.

You may be burning up ECU's here. The limp mode failure is known to subsequently burn out the ECU. I have burned one in my S5 vert.

Here is a link to the best thread on the subject:
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/s5-mop-ecu-failure-diagnosis-710938/

Good luck!

CALPICO

iTrader: (4)

i had the same problem as you and I just decided to go with Premix in the gas + rtek on the ECU. works great now! good luck

MidnightZed

iTrader: (1)

Kinda off topic, what color S5 TII is this? I think I may know who's car this is hehehe

Ryan_13b

iTrader: (3)

Thanks that info makes sense now.. dam...that sucks ...


LOL its a customers i dont know his name dark blue s5 with nissan r32 wheels up front

philiptompkins

iTrader: (4)

nevermind,I searched and found it.... apparently the rtek 1 for the n/a s5 is ONLY to get rid of the OMP