RPM bouncing

Reply Subscribe

Thread Tools

Search this Thread

May 17, 2004 | 09:05 PM

laoplayboyz

Thread Starter

Newbie

Joined: Aug 2003

Posts: 4

Likes: 0

From: Montreal

RPM bouncing

The TPS should be adjusting to how much ohms normaly???

May 17, 2004 | 09:21 PM

Hollywood56

Full Member

Joined: Apr 2004

Posts: 155

Likes: 0

From: Miami

1000 ohms .Check with the multimeter to make sure you do not have any dead spots on the tps.If there are any then its time to buy a new tps.Make sure to warm up the engine good before adjusting it too.Good Luck

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Please help!!

dona1326cosprings7

1st Generation Specific (1979-1985)

Oct 29, 2015 06:47 AM

84SE Engine Swap Success! Surge at idle, clutch out.

LongDuck

1st Generation Specific (1979-1985)

Oct 7, 2015 08:12 PM

Good help needed with BorgWarner S300SX-E setup!

eplusz

General Rotary Tech Support

Oct 7, 2015 04:04 PM

Cold Start Idle Issue

Einheri

Single Turbo RX-7's

Oct 7, 2015 12:23 PM

88 T2 power loss at above 6k

musker

New Member RX-7 Technical

Oct 1, 2015 05:58 PM