rotor oil seal o-ring bad?
Thread Starter
aim** JI II IM IM Y
Joined: May 2005
Posts: 495
Likes: 0
From: 90703 cerritos california
rotor oil seal o-ring bad?
I had to take out my just-installed rotor oil seal o-rings for the rotor bearing to be pressed in. Now, after trying to put them back in, they will not seal and justs pops out. What could be the problem?
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
First - like Ted said.
Then:
I use 2 clean blocks of 2x6 lumber.
Position the board, rings, rotor, rings, board sandwich on the floor & stand on it.
After a few seconds the O-rings will squirm into position.
Then:
I use 2 clean blocks of 2x6 lumber.
Position the board, rings, rotor, rings, board sandwich on the floor & stand on it.
After a few seconds the O-rings will squirm into position.
Last edited by SureShot; Aug 22, 2006 at 07:36 AM.
Thread
Thread Starter
Forum
Replies
Last Post
