2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

replacing fuel lines

Thread Tools
 
Search this Thread
 
Old Feb 17, 2005 | 01:11 AM
  #1  
gingenhagen's Avatar
Thread Starter
I am 2Furious
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 846
Likes: 0
From: NJ / Philly
replacing fuel lines

Dunno where my fuel smell's coming from. FPD wasn't leaking, but replaced it with a banjo bolt anyway. So now I'm looking to replace my fuel lines (which look old and cracked anyways). What options do I have?
Reply
Old Feb 17, 2005 | 01:19 AM
  #2  
Project84's Avatar
Open up! Search Warrant!
Tenured Member 05 Years
 
Joined: May 2002
Posts: 3,838
Likes: 3
From: Kicking down doors in a neighborhood near you
You can go to the nearest auto parts store and get some 5/16" ID fuel hose. Make sure it says something to the effect of "fuel injection rated". Napa, Kragen, and just about every other auto parts store will have it.

Or you can get expensive and get steel braided hose, change out the banjo bolts on the fuel rails with -AN fittings, and go that route.
Reply
Old Feb 17, 2005 | 01:41 AM
  #3  
ilike2eatricers's Avatar
I R SAD PANDA W/O BAW
 
Joined: Nov 2002
Posts: 6,061
Likes: 1
From: bay area
High pressure fuel injection hose is pretty expensive already. I think last time I bought some it was 8 or 12 cents/inch.
Reply
Old Feb 17, 2005 | 02:47 AM
  #4  
unek87's Avatar
NA-BOOSTIN
Tenured Member 10 Years
 
Joined: Oct 2004
Posts: 1,200
Likes: 2
From: austin,tx
you guys in cali get taxed like no other . over here its .80 cents a foot if not cheaper
Reply
Old Feb 17, 2005 | 03:13 AM
  #5  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Originally Posted by gingenhagen
Dunno where my fuel smell's coming from.
Jumper the yellow fuel pump check connector by the RHS strut tower in the engine bay, turn the ignition on, grab a torch and look for leaking fuel. This will save you the money spent randomly replacing okay parts until you find the culprit. Don't forget to remove the jumper wire before driving.

Actually before you do that, check all the evaporative emissions hoses to and from the charcoal cannister, plus the cannister itself. It's job is to absorb fuel vapours while the engine's not running, so any damage will cause a fuel smell.
Reply
Old Feb 17, 2005 | 07:05 AM
  #6  
MechE00's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Jun 2002
Posts: 243
Likes: 0
From: Philly, Pa.
<weeny>Note: A "torch" may also be known as a "flashlight" in the US parts.. don't go looking for fuel leaks using an open flame.. :p </weeny>
Reply
Old Feb 17, 2005 | 07:24 AM
  #7  
capn's Avatar
Mechanical Engineering
Tenured Member 20 Years
 
Joined: Jun 2004
Posts: 1,618
Likes: 26
From: South Carolina
you could have rusted steel lines if your car has been subjected to salt and bad road contions. or your car has been sitting a while. and thier about $115 from the dealer which is the only place you can get then. but lets not hope its that. and i bought 20' of fuel injection hose for $25. but now i dont have to worry about getting more hose
Reply
Old Feb 17, 2005 | 07:30 AM
  #8  
BlaCkPlaGUE's Avatar
I live in an igloo
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 2,546
Likes: 0
From: calgary alberta
Actually before you do that, check all the evaporative emissions hoses to and from the charcoal cannister, plus the cannister itself
exactly what I was going to recommend. All the people that I know of that removed thier charcoal canistor have mentioned fuel smells coming from the engine bay.


LMAO at the torch, I was convinced NZconvertable that you meant get a blowtorch and start lighting fuel fumes up to find them! lol
Reply
Old Feb 18, 2005 | 12:31 AM
  #9  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Well it would work wouldn't it?

Yeah, that would be torch as in a flashlight, not a gas torch.
Reply
Old Feb 18, 2005 | 05:26 AM
  #10  
gingenhagen's Avatar
Thread Starter
I am 2Furious
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 846
Likes: 0
From: NJ / Philly
Well, the fuel smell's coming from the driver's side of the car.
Reply
Old Feb 20, 2005 | 04:20 AM
  #11  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
You need to be looking at the vacuum and fuel hose diagram in the FSM. It clearly shows where the hoses you need to check are.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
sYnth.
Build Threads
0
Aug 19, 2015 06:27 PM
GrossPolluter
2nd Generation Specific (1986-1992)
4
Aug 16, 2015 09:50 AM




All times are GMT -5. The time now is 08:53 AM.