Reading Compressor Maps for Rotarys
11-01-04, 02:19 PM
#1
Full Member
Thread Starter
Join Date: Apr 2002
Location: Portland, OR
Posts: 145
Likes: 0
Received 0 Likes
on
0 Posts
Reading Compressor Maps for Rotarys
Hey guys i am trying to figure out a way to be able to read a compressor map to where it would work out for a Rotary motor...
from what i have noticed with some of these is that if using Piston formulas to try and Plot a point on the map it wont work very accurately...
any help here? yes i know what turbos are good for them, But i am just wanting to be able to look at a map, with the boost i want, and be able to look at a Turbo that people havent tryed before *or isent commenly used* and see if it would work good for my applecation..
right now i have a Compressor map for a 60-1 to be able and compare with.. i know the rotarys love this turbo so i figured its a good place to try and see if the calculations work with it..
Jesse
from what i have noticed with some of these is that if using Piston formulas to try and Plot a point on the map it wont work very accurately...
any help here? yes i know what turbos are good for them, But i am just wanting to be able to look at a map, with the boost i want, and be able to look at a Turbo that people havent tryed before *or isent commenly used* and see if it would work good for my applecation..
right now i have a Compressor map for a 60-1 to be able and compare with.. i know the rotarys love this turbo so i figured its a good place to try and see if the calculations work with it..
Jesse
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
befarrer
Microtech
3
08-22-15 05:52 PM