re mirror install/mount?
07-29-10, 08:35 PM
#2
If you are talking about the RE-Amemiya low profile mirrors you use two long metric screws into the two holes that line up.
I put some thin weatherstripping foam around the edge of the mirror to prevent gaping and used washers and locktite on the screws as you do not want to over torque them and stress the thin fiberglass of the mirror housing.
If you are talking about something else relating to mirrors- sorry, but your question was really vague with only the RE in the title and the two holes lining up making me think of my experiences with the RE Amemiya mirrors.
I put some thin weatherstripping foam around the edge of the mirror to prevent gaping and used washers and locktite on the screws as you do not want to over torque them and stress the thin fiberglass of the mirror housing.
If you are talking about something else relating to mirrors- sorry, but your question was really vague with only the RE in the title and the two holes lining up making me think of my experiences with the RE Amemiya mirrors.
07-29-10, 09:06 PM
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2007
Location: Englewood/Dayton Ohio
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
u have the right ones in mind... sigh my painter must have overtorqued them.... the drivers side had one break out... prolly because no foam or rubber to soften the blow from shuttin door and everything...
Thread
Thread Starter
Forum
Replies
Last Post
