Ok so i did this engine swap ages ago, and my car is still not running. I took it to a shop, and they cannot figure it out for the life of them... basically the problem is that the car will not spark. the coil is good, the ignitors are good, the pulgs are good and the wires are good. The ECU was just replaced. any ideas?

 

Just a few suggestions. Trace down the wiring associated with the ignition system and verify everything is connected according to the factory service manual wiring diagram. Check for lack of continuity in the wiring. Check the ignition switch. Check the clutch switch that disables the ignition. Test the coil/igniters according to the FSM procedure.

You can download a copy of the FSM from one of the links in the 2nd gen FAQ.

 

i had this same problem because i was using the jspec harness now that i switched to the US harness it sparks all day