2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

problems with alarm and starting

Thread Tools
 
Search this Thread
 
Old 07-02-11, 08:47 PM
  #1  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
problems with alarm and starting

I use my 86 NA stock as my daily everyday. But 5 days ago, when I was driving home after work(45-50mph), this interesting beep went off. It lasted for about 5 seconds then it went off. I was assuming it was the add coolant alarm but there was no light popped out. After I got home, i checked and I found nothing. No steam, no smell of hot coolant.

A day later, at the exactly same spot, same time, this beep went off again. And I did the same thing and checked it, nothing.

Today, I went to this restaurant, then I went this little store to get some snacks. After I came back out, the car wont start nor crank. The battery is good and the volt is reading around 12.5-13. I also checked the fuse and there is none blown fuse. I am thinking it might be flooded? but the car wont even crank, any other ideas? thanks
Old 07-02-11, 10:23 PM
  #2  
Moderator

iTrader: (1)
 
satch's Avatar
 
Join Date: Jun 2005
Location: tulsa,ok.
Posts: 11,738
Received 12 Likes on 11 Posts
Is the the alarm a factory unit or not?
Old 07-03-11, 12:08 AM
  #3  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
100% stock car
Old 07-03-11, 02:17 AM
  #4  
Moderator

iTrader: (1)
 
satch's Avatar
 
Join Date: Jun 2005
Location: tulsa,ok.
Posts: 11,738
Received 12 Likes on 11 Posts
You should have a relay located between the Main Relay and the trailing coil and this would be the starter cut relay. It has two Black/Green wires where one is thicker than the other. Jumper a wire between this thicker B/G wire and The Black/White wire at this particular relay while the car is not in gear and see if the car turns over as you turn the key to start as it should. If you have the interlock switch which requires the clutch to be depressed than also do that as a prep to start the car otherwise just turn the key to start w/the jumper in place.
Old 07-03-11, 09:10 AM
  #5  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
thanks for the help! I will try that later after i get home from work. So this is not a flooded problem right?
Old 07-03-11, 11:54 AM
  #6  
Moderator

iTrader: (1)
 
satch's Avatar
 
Join Date: Jun 2005
Location: tulsa,ok.
Posts: 11,738
Received 12 Likes on 11 Posts
You stated "the car would not crank," which to me means it won't turn ove,r which is not a flooding issue.
Old 07-09-11, 08:12 PM
  #7  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
Oh ok, so how do I fix the problem if the car starts? and what if the car does not start, what could cause the problem?
Old 07-09-11, 08:58 PM
  #8  
Moderator

iTrader: (1)
 
satch's Avatar
 
Join Date: Jun 2005
Location: tulsa,ok.
Posts: 11,738
Received 12 Likes on 11 Posts
Did you do as suggested in post #4? You have to start somewhere. Don't you?
Old 07-10-11, 06:05 PM
  #9  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
Still haven't had time to try it yet until tomorrow, will defin get back to you. thanks for your help!
Old 07-13-11, 03:57 PM
  #10  
Banned. I got OWNED!!!
Thread Starter
iTrader: (10)
 
devilxavierz's Avatar
 
Join Date: Sep 2010
Location: Irving TX
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
Ok, I unplugged it, wiped it clean and changed the spark plug wire set, then it started right up! Didn't get a chance to try out the jumper wire but thanks!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
cristoDathird
Introduce yourself
28
05-30-19 08:47 PM
alphawolff
1st Generation Specific (1979-1985)
17
11-17-15 05:57 PM
1993fd3sracer1
3rd Generation Specific (1993-2002)
29
10-13-15 01:57 PM
1993fd3sracer1
1st Generation Specific (1979-1985)
20
09-07-15 11:50 AM



Quick Reply: problems with alarm and starting



All times are GMT -5. The time now is 10:02 PM.