Recently i swapped the power windows from my old door which was damaged at the time i bought the car into a new door. The problem im having is that the motor will continously run the lift arm down, even if the window is down and will hop over the ball chain. Ive plugged a switch in and held the drivers side window in the up position and still no change. I have no idea what the heck is wrong so im calling upon the electronic guru's and power window wizards . Thanks in advance

-Tyler

 

I forgot to mention, the car is a 87 N/A if that helps.

 

bad switch

 

Ive tried it with two switches now and it still does the same thing. It also does it when i dont plug in any switch and plug the power window harness in any ideas?

 

its rolling up the window with the switch plugged in???

if so then you have the motor hooked up to the wrong plug (probably the door light plug).

 

well mind dont work at all... 87TII

no responce from windows when i hit the switch..

jaared

 

Take your door panels off and check for a loose connection. My dad's car does that too and I think it is just a loose connection. And I have also fixed a couple cars with this same problem. There is a plug for a bunch of wires, like a male and female plug type if you know what I mean. They plug into one another, it comes loose quite easily on most cars....could be your problem. If not then I have no idea.

 

We'll unfortuneately now ive found out that the edges on the drive wheel are rounded over. Time for a run to the auto wreckers