power steering pulley/engine swap questions...
#1
Junior Member
Thread Starter
Join Date: Dec 2003
Location: minneapolis
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
power steering pulley/engine swap questions...
I blew an apex seal in my engine and am in process of swapping in a used engine. Progress is slow following the Haynes Manual. I need to get the power steering pulley off. Went over to Sears and bought a gear/pulley puller. I...uh...I need a new power steering pulley now. Instructions say nothing about a little piece I can see (now) in the schematics. Looks like a small rectagular something or other. What is it? How to get out?
Also, any tips of better/easier way to do things. Things I will run into etc. I'm starting a "things I broke while trying to get my engine out" list. I want to keep it as short as possible.
Oh, anyone have a spare power steering pulley layin' around?
Thank you,
dave-87 rx7 n/a
Also, any tips of better/easier way to do things. Things I will run into etc. I'm starting a "things I broke while trying to get my engine out" list. I want to keep it as short as possible.
Oh, anyone have a spare power steering pulley layin' around?
Thank you,
dave-87 rx7 n/a
Thread
Thread Starter
Forum
Replies
Last Post
LunchboxCritter
2nd Generation Specific (1986-1992)
15
01-03-16 04:11 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM
JIMMY54
1st Generation Specific (1979-1985)
2
08-12-15 05:40 PM