Hey guys been building my 91 rx7 13b na. Found out the upper injectors were clogged and the leading coil pack is bad. So i figured while i had the intake manifold off id remove somethings that are not needed. From doing some reading the port air solenoid is one of them. If anyone has or knows of a link of a step by step guide on what all i need to do to remove it, it would be greatly appreciated.

Thanks in advance. David

 

Port air solenoid or the entire ACV?

Next question, mind a check engine light?

 

honestly i dont know, i was thinking the port air but whatever i can remove is helpful. has a check light for the port air, but the cats were already removed and im guessing thats why?

 

The ECU doesn't know if cats are present or not, so removing them will not trigger a MIL.

 

ok i wasnt sure. The check light is for the port air so i figured removing it would be a good idea since its not needed.

 

Why is it no longer needed?

 

woa not needed? are u sure it's a good idea?

 

Just unplug it. It's at the top of the engine. Port air MIL light should only be at idle. It will go off once you start moving.