Please help!.. my clutch is sticking to the floor! whats wrong?!!
#1
dorifuto soko!
Thread Starter
Join Date: Apr 2008
Location: winston salem NC
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Please help!.. my clutch is sticking to the floor! whats wrong?!!
so i just got back from a drift comp. and i noticed my clutch felt wierd, so when i got home i saw the fluid was a bit low.. i added some and didn't think much about it. then i just got in my car again and the clutch pedal is sticking to the floor! it goes in and out of gear fine. but the cluch is sticking so i have to wedge my foot underneath it to pull it up!!
#3
Ban Peak
iTrader: (49)
so i just got back from a drift comp. and i noticed my clutch felt wierd, so when i got home i saw the fluid was a bit low.. i added some and didn't think much about it. then i just got in my car again and the clutch pedal is sticking to the floor! it goes in and out of gear fine. but the cluch is sticking so i have to wedge my foot underneath it to pull it up!!
ZOMG! DISASTER!
You need to sell your car or it will catch on FIRE!!!
If you did a quick search you'd find out it happens all the time. Somethign in your clutch hydraulic system failed. If I was you I'd replace both the clutch master and slave cylinders. One of them is bad.
#7
Rotary Enthusiast
iTrader: (18)
Join Date: May 2008
Location: Texas BABY!
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
Just bleed it, i bet that fixes it, also if your fluid is black, then bleed ALL of the old fluid out, do it until the new fuild is all that comes out. I just did this to mine and it works perfect.
Trending Topics
#8
Drivin without Pistons
Join Date: Apr 2002
Location: Wilmington, NC USA
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
If you bleed everything and your still having issues I would suggest rebuilding the master cylinder. I had the same problem you are having and after bleeding it still went to the floor. After opening up the master cylinder I looked at the spring that is inside of it and compared it to the new one and it was compressed too much. Once I reinstalled the new pieces everything worked great. GL
#9
dorifuto soko!
Thread Starter
Join Date: Apr 2008
Location: winston salem NC
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
yeah thats what i was planning on doing, cause my car had sat for awhile before i got it so the little things like that are still all dirty.. haha i hope that fixes it cause i'm tired of spending so much money on making my car run.. i want to spend money on tunning it!!!
hhaa
Thanks alot you guys
hhaa
Thanks alot you guys
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM