I can't remember where the washer goes by the pulsation dampner. Theres the rail...the feed tube deal, the PD...i put the washer between the rail and the feed tube...is that where it goes? Thanks.

 

Err. there should be like two of them
one between the fuel rail and one on the other side of the 'feed tube' thingy in-between it and the PD.

 

Try Madatrix.com

 

u sure theres two...i could have sworn there was only one...hmm.....no go on the mazdatrix website...

 

yup there are two of them.

 

theres only one loose one or removable one...the other one is built onto the pd...i just took apart my spare rail...i got it right the first time. thanks though.

 

seriously there are two I replaced my PD myself two crush washers are neccessary. One is probably stuck onto the rail or the PD just try to take it off. They get really stuck on there.

 

ok....ill take it off sice all ive assembled so far is my lower manifold and prim. fuel rail. I'dl like to replace them..but i wonder if one of the same size will work or if it has to be exact mazda one. I didnt see anything like that on Mazdatrix..hmm...re-use em?

 

There are DEFINATLY two crush washers, yes one or even two of them very commonly stick to the PD...

 

yes you can reuse them, just clean them and make sure they don't have any obvious imperfections..

However I bought 3 new ones for all of about 50c at my local hardware store.