And one more question...
08-27-01, 01:10 PM
#1
Full Member
Thread Starter
Join Date: May 2001
Location: Junction City, KS
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
And one more question...
I have my upper maniflod/TB off right now (see my post "more brave than smart"). I have the gaskets to do the lower maniflold to block & the O-rings also. Should I even mess with pulling the lower intake? Is it more trouble than it's worth?
08-27-01, 02:51 PM
#2
Formula Mazda Driver
Join Date: Feb 2001
Location: Portland, Oregon, USA
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
I'd say go for it if you have the gasket. You might as well do it so you don't end up having to do down the road if the old gasket goes. Its just a few more bolts. Of course I've only done this on my 90NA, but I'd assume its a pretty similar procedure.
08-28-01, 10:51 AM
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
If it is'nt leaking now, I'd probably not mess with it. It works. The problem is the two o'rings during reassy. Not a big problem, but a possible problem if they get pinched etc during reassy and then you do not find that out until everything is put together. Either way is fine. No risk, is leaving it alone.
Thread
Thread Starter
Forum
Replies
Last Post