Well like i said the other day, the rx7 is running, but i only had it running for a couple mins. I had to replace the coolant pressure cap for the radiator. Well i put it on today, and tried to start it (didnt start) and thought it was just over flooded like always for my car. so i look around, and see that theres coolant leaking. between the irons and the housings. I opened up the new cap and it was pressureised. What to you guys think. i did the tension bolts for the motor EXACT to the stock spec. what do i do?? I made sure all my seal were in right. god i hate being confused.

 

**** me thinks i might of fucked up one of the coolant seals and that im pressurizing the whole coolant system. what do u think? could it be possible. i sat that mother down like 4 times making sure it didnt pinch thouhg. god id hate it if i had to part out my motor

 

Sounds like it was pressurized and created a leak becuase of too much pressure. Might have had a seal or something that was weak and once it was pressurized it couldn't hold. Might be a small leak, might be why there's still pressure?

 

That or it's leaking from somewhere else and it just looks that way, though that's not as likely.

 

well i think i pinched a coolant seal. that is a big possibility, i found a peiceof plastic on my rear spark plug. Im guessing its pinched. oh well. time to part out. check for my for sale. its being stripped somtime tomarrow or sometime else this week.