ok my oil meteing lines just all melted together... so im going to make new ones out of rubber hose for a tempary fix. they will be covered with steel braid too. but i need toknow what lines go to where on the oil metering pum pls help... need to get together by tomarrow

 

It should be pretty easy to figure out which one went where, as they are molded to fit to ONLY one oil injector, but if you look in the FSM, I believe there is a diagram.

 

Scalliwag sells a set of stainless steel ones if you'd like something nice that will definately last.

 

what is the fsm

 

factory service manual

 

f s m .....family sex manual

 

that how they do it in texas hailers?

 

ive got some if you need them.

 

I didn't think it made a difference of which oil line went were (housing or LIM).

 

i am starting to think they dont make much of a difference. upon installing a new engine in mine, the service manual didnt seem to mention anything about which goes where. anyway, i know i got at least two of them where they should go, the other two, well i will just have to see.

 

What can I say? Oil/vaseline whatever works. I'm only halfway thru the manual and having fun.

The fsm shows where each oil line goes where on the metering pump. That said, it does not matter if it'll reach from the injector to the pump. They all meter the same amount of oil.

 

I tried rubber hoses on oil meter once....hot oil deteriorates the rubber like really quick...if you aint careful oil will be going everywhere except into the engine and you know what happens then.............................POOOOOOOOOOoooooF FFFFffff...........

 

agreed, dont do it, not wrth the hassle