Odd idle problem
Odd idle problem
Ok, Ive searched tons on of threads on idling hoping to fix mine to no avail. TPS is adjusted to spec, and Ive tinkered with both of the idle screws to get an ok idle going. Here are the symptons.
1. Idles at about 1500rpm, but once it idles for awhile it will usually just die.
2. If Im driving at anything higher than around 3000rpm and put my foot on the clutch to brake, it will die immediately.
3. When I start it after it dies when Im not rolling( or else Ill just dump the clutch to start it) it will idle fine for awhile, which leads me to believe that the engine warm-up is what is helping it idle.
My streetport was done with Mazdatrix templates so I dont think its the motor. PLEASE HELP IT DRIVES ME CRAZY!!!
1. Idles at about 1500rpm, but once it idles for awhile it will usually just die.
2. If Im driving at anything higher than around 3000rpm and put my foot on the clutch to brake, it will die immediately.
3. When I start it after it dies when Im not rolling( or else Ill just dump the clutch to start it) it will idle fine for awhile, which leads me to believe that the engine warm-up is what is helping it idle.
My streetport was done with Mazdatrix templates so I dont think its the motor. PLEASE HELP IT DRIVES ME CRAZY!!!
5,000 miles on rebuild. Motor runs good and puts out plenty of power. COmpression is good. No vacuum leaks, Ive checked alot.
AFM can cause this???
I havent thought about fuel filter yet, its probably time to replace it anyways.
AFM can cause this???
I havent thought about fuel filter yet, its probably time to replace it anyways.
Joined: Dec 2001
Posts: 10,630
Likes: 3
From: NY, MA, MI, OR, TX, and now LA or AZ!
The AFM can cause quite a few problems, swap it out, if it doesn't go away, try the complete tune-up, if it's still there, then you've got some more digging to do.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
barkz
Power FC Forum
37
Nov 21, 2020 09:34 AM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM



