litlred515

Ok so my car would just totally lose power at around 4k right when the secondaries kick in. So i went and got some that were just cleaned and blue printed put those in and it still has no power at 4k on up. What else could it be? I was thinking pissibly the resistor pack but would that just make 2 of them stop working if it went? TIA

Black13B

iTrader: (1)

Bad ground to about a million different things causes the hesitation.

You sure your Aux ports are even opening?

litlred515

it's not the famous hesitation. There's no power from 4k-redline. my ports are wired open so i know it's not that.

J-Rat

iTrader: (2)

So, describe "no power". Can you reach the redline? Do you have to keep your foot BARELY on the gas to do it?

litlred515

That's exactly it. So what do i do?

J-Rat

iTrader: (2)

Figure out why your Secondaries arent coming online.

Check the easy stuff first, connectors, etc...

litlred515

Ok i'll have to check everything tomarrow, but this might have something to do with it, when i run the sensor check on my safc the first reading is around 4v and it used to be around 2. anyone know why this might be and what would cause this?

rx7raca

are u sure u put them in rite? maybe put them in so they dont face the port, i almost did that.

litlred515

the injectors face straight down and the connector points straight out. how can you put them in wrong?