yeah, so finaly i got my car together RIGHT!! sent the motor out to banzai, replaced what i had to and had them rebuild it with a street port, got a good base map to throw in m datalogit for the FD Poer FC which is hooked up using the banzai adapter and everything is good, so it seems...but i go to fire her up and nothing!!! i check the harness and some other **** and still nothing

then i pull the l2 plug wire and put it on a plug and ground it and crank, no spark! i no i got the secondary coil righ this time around as i fixed it last time and got it to work, so i am not worried about that...but i checked everything i could think of and still no spark. i brought out another "crank angle" sensor and pluged it in and spun it, got the plug to spark, swaped CAS and went to turn it over and again no spark....idk y it'll spark with the CAS out of the engine but not with it in....but idk what else to check...any input guys???

 

check the wires to the cas. sometimes they get brittle and break in the harness.