New clutch and flywheel, now car wont start...
#1
Junior Member
Thread Starter
Join Date: Feb 2010
Location: Pa
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
New clutch and flywheel, now car wont start...
So I had just finished installing a spec stage one clutch and a fidanza flywheel onto my rx7 and while i was at it i installed a new starter because while i had it off i had it check and it was bad... So everything is installed and ive tried turning the crank with a ratchet and it will turn and also if i put the car in gear the rear wheels will turn when i turn the crank with a ratchet so i believe the clutch and flywheel were installed correctly so my question is what would of caused my car to not start?
#4
Are you experienced?
iTrader: (18)
Did you connect the power cable and small cable to the starter? If you are missing those two things = no start.
Do you have the battery connected?
Did you remember to connect the starter ground connector to one of the transmission bolts on the drivers side? Its easy to miss.
If all these are good, bad starter.
Do you have the battery connected?
Did you remember to connect the starter ground connector to one of the transmission bolts on the drivers side? Its easy to miss.
If all these are good, bad starter.
#6
MECP Certified Installer
Trending Topics
#8
MECP Certified Installer
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM