I have an MSD 6AL that I am putting in my car on the leading ignition. I need to know what configuration does the MSD require to work with the rotary - 4, 6, or 8 cylinder?? Thanks for your help.

 

I not sure but I think it should be on 4 cyclinder mode.

 

Run it as a 4-cylinder - the rotary fires once every "crank" rotation, which is the same thing as a 4-cylinder.


-Ted

 

4 cyl

 

don't forget that on rx7 the body is a floating ground, bolt the ground off the msd to the chassis.if not it will not work it all.

 

Huh?
The RX-7 runs a negative chassis ground - not floating.
Connecting the MSD to the chassis is not recommended.&nbsp Even MSD writes in it instructions to put the thick black wire directly to the battery.



-Ted

 

heya, isnt the 6AL rev limited to 6000 rpm? or is the rpm count from the ignition different somehow for a rotary.

 

The rev limiter is "useless" if the CDI box is only installed on the leading coils.&nbsp The trailing coils will happily keep pushing the engine higher into the revs.&nbsp You need to install some kinda rev cut on all three channels (single leadings and both trailings) for a rev limited to be effective...


-Ted