Hi everybody, this is the first time Ive done a turboii swap Im having trouble figuring out the fuel injector harness I dont know what one goes where. Im also trying to install a greddy emanage ultimate does any body know the jumper settings for rotory engines? Any help would be helpful! Thank you very much

 

alright what im trying to figure out is does any one know what the primary and secoundary injectors are thanks

 

Primary injectors are the two injectors in the engine block (intermediate housing, actually). The secondaries are on the inside of the intake manifold (on a turbo II) and on the outside of the intake maifold on a N/A. One in the front runner, one in the back runner.

I hope this helps.

 

thank you now the only thing im un sure of is the harness does it matter. is it wired for primary and secoundiary?

 

the harness has to be connected to the right injector either front or rear.shorter injector clip/wire goes to the primary longer for the secondary.it won't reach otherwise.

 

also does any one know if i use a manuall boost controller do i need the factory map looking sensor