Need help--Tii swap
Hi everybody, this is the first time Ive done a turboii swap Im having trouble figuring out the fuel injector harness I dont know what one goes where. :wallbash: Im also trying to install a greddy emanage ultimate does any body know the jumper settings for rotory engines? Any help would be helpful! Thank you very much
|
alright what im trying to figure out is does any one know what the primary and secoundary injectors are thanks
|
Primary injectors are the two injectors in the engine block (intermediate housing, actually). The secondaries are on the inside of the intake manifold (on a turbo II) and on the outside of the intake maifold on a N/A. One in the front runner, one in the back runner.
I hope this helps. |
thank you now the only thing im un sure of is the harness does it matter. is it wired for primary and secoundiary?
|
the harness has to be connected to the right injector either front or rear.shorter injector clip/wire goes to the primary longer for the secondary.it won't reach otherwise.
|
also does any one know if i use a manuall boost controller do i need the factory map looking sensor
|
All times are GMT -5. The time now is 08:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands