need help quick
#1
rotary tech
Thread Starter
iTrader: (9)
Join Date: Jan 2007
Location: tracy/stockton ca
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
need help quick
so i just finished installing my motor everything went fine i took it for a little spin came back fixed a found oil leak. sitting around for a while and decided to move it and call it a night but when i turned the key no power at all nothing works head lights nothing check'd all my fuses not a single one was blown . did i just fry out my whole car.
#3
rotary tech
Thread Starter
iTrader: (9)
Join Date: Jan 2007
Location: tracy/stockton ca
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
good news good news my starter cable was **** it burnt out. i bought a battery cable from auto zone to check it with the battery hooked up to the starter and everything else and POW!! no problem starting. so im going to pick up the necessary cable tomorrow since my battery is relocated. my dumb *** used the wrong type of wire. well you live and learn i guess thanks for all the help to the guy above you really made me look at my wires carefully. i didn't find any obvious stuff but just started thinking about it
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM