does anyone have it?

 

No such animal available.

 

There you go.

 

Mazda does not release such proprietary information.
Unless someone takes the time to trace all the traces, no such beast exists.


-Ted

 

that sucks

 

I know this is old , but I am working on a project trying to get one to power up. I got a print out from mitchell ondemand and the only wire that looks like power is white/blue (3J) going to fuse#3

I'm trying to keep the elctronic dizzy and coil packs, I have asked a few people and every one told me to just swap out with the points (not a option) I got the parts in front of me to do this

the car was a 87 N/a (fuel injection pulled off and carbed) 5 speed (if that matters)


swaping in to a 86 B2000.

at this point the small block ford would of been funner

 

Factory service manual, downloaded from this site........FUEL AND EMISSIONS section..........Control Unit pages describe the input/output wires of the ECU. And the wiring diagrams are in the wiring diagram section. See FAQ for the downloads.

Pins 3I and pin 3J power the ECU. One of which can be disabled and the ECU will still work flawlessly.

 

I didn't catch 3I comming off the main relay (black-white) i'll give that a shot
hope to get some spark soon can't wait to fireup this 13B again


thank you