osiris7

hey guys i got a 88 t2 and cant get enough of the turbo spooling up..Is there any way to make the noise louder than it is..by the way the cars completlely stock with a HKS mega flow filter..thanks

No7Yet

Get a downpipe.

Brandon

osiris7

oh yeah it already has a down pipe.any one else?/i know you guys with t2's love the sound of spooling.LOL!!!

gsracer

TID mod. You will hear it spool VERY loudly. Don't do it unless you have your fuel undercontrol though.

osiris7

hmmmm tid mod, never thought of that..I need to do a search for TID mod..thanks

HeffBoost

gsracer is right. The mod is very good for performance too. It does make that lovely noise a lot louder.

600HP CLUB

or spend a thousand dollar or so for haltech.
and rip everything out and use a chicken fence over the turbo

dr0x

Take off the downpipe, and run no TID on the turbo. It will be very loud, also might suck dirt into the engine..... Id recommend keeping a filter on it

RX7withNitrous

upgrade your turbo

nonameo

would I see a good increase in performance from putting a cone filter directly on the turbo VS the tid mod? or will it not be much at all?

RexRyder

iTrader: (10)

run an exhaust cut off? DIY BOV, port waste gate?

AW11Rkt

You cant run a filter directly over the turbo unless you are running a VPC or standalone . You have to put the filter on the AFM , or the car will basically just be a big vaccum leak and it wont run .

A nice TID and that Supermegaflow on it should make a nice loud spool sound .

dr0x

s5 AFM's you can mount on an intercooler pipe or the such.

nonameo

I know. I am building a megasquirt which uses MAP sensor tech. so what about performance again?

osiris7

damn alotta good ideas here..im gonna get the write up on the TID mod and hopefully all goes well..thanks guys..!!

dr0x

You dont need a write up. Stick pipe onto turbo, afm onto pipe, filter onto afm.

Aaron Cake

iTrader: (1)

Get one of those little ricer noisemakers that fit inside the muffler. Put it in your intake.

Also, you can take some chips out of your compressor and/or turbine wheel. Then it'll wail...

DC350

get a T-88 and a 75 shot nitrous to spool it up

RexRyder

iTrader: (10)

u kno u guys reminded me of this one muffler i saw in i think a JCWhitney catalog. it was by like some orange company with a toucan as for logo i think. neway the muffler has a little turbine in the tip, so everytime u rev, the exhaust gases spool up the turbine at the tip of the muffler an u get this cool "turbo sound" cool huh?

RexRyder

iTrader: (10)

here it is if neone interest:

madaz07

ive got microtech MT-8 ecu so i dont have the AFM and other ****, ive just got a K&N pod filter on the original intake hose and the spooling noise is loud as and i love it

Josepi

I'm in on the group buy, so I'll be in the same boat soon!