just ogt rebuild started.and oil pressure maxing out??
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
just ogt rebuild started.and oil pressure maxing out??
my oil pressure guage is maxing out my guage cant even read it its so high.what gives how can i fix this what might be the problem is this bad???
and also my temp guage isint working where is the sendor for it located??
and also my temp guage isint working where is the sendor for it located??
#3
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
well im not sure i can hold it at around 2k rpms but if i let off the gas it dies but i thought that was from the fresh rebuild it hasnt even been running for 10 minutes yet.
there are only 2 ground terminals on the harness and they have very good grounds/.
since my temp guage dosent seem to be working is it possible to hook up the oil pressure wrong?
there are only 2 ground terminals on the harness and they have very good grounds/.
since my temp guage dosent seem to be working is it possible to hook up the oil pressure wrong?
#4
U.S. Army Recon 93-04
Join Date: Feb 2007
Location: Seminole,Fl
Posts: 428
Likes: 0
Received 0 Likes
on
0 Posts
well im not sure i can hold it at around 2k rpms but if i let off the gas it dies but i thought that was from the fresh rebuild it hasnt even been running for 10 minutes yet.
there are only 2 ground terminals on the harness and they have very good grounds/.
since my temp guage dosent seem to be working is it possible to hook up the oil pressure wrong?
there are only 2 ground terminals on the harness and they have very good grounds/.
since my temp guage dosent seem to be working is it possible to hook up the oil pressure wrong?
How did you manage to get the car running?
Thread
Thread Starter
Forum
Replies
Last Post