i know there was a thread about this 10 billion years ago but i couldnt find it. if u can show me a visual of how to correctly install s5 tail lights to a s4 fc i would appreciate it. thx

-jimmy

 

i think you just beet a couple spots in with the hammer or cut it out to get them to fit?

 

i remember the beat the spots with the hammer part but where??

 

Step one remove the S4
Step two try to fit the S5
Step three bend back the peice of metal near the license plate that's in the way
Step four fit the S5 lights


seriously, It's pretty obvious. Just use your head, a touch of commonsense, and a pair of pliars and you too can have the freedom of fabrication

 

http://www.aaroncake.net/rx-7/taillights.htm
picture shown^^

 

thx guys

 

um i have an S4 and i swapped the S5 taililghts in. and i didnt have trouble with it...my taliight setup(dont know what its called) molding?? already had an indent like the one that was suppose to be made. so try fitting it on first?

 

I have an S5 with S4 tails. The S4 guys make it near impossible for me to get S5 replacements.

 

i know what you mean...
you know how hard it is to get a t2 hood because the na guys kept buying the t2 hood to cool their.... tps????

 

Thread closed. Covered in the FAQ for FC sticky thread found at the top of this, the 2nd gen RX-7 technical section.

Please read the FAQ for FC before posting. It covers many of the commonly asked questions such as the one this thread was started with.

Thread closed