injector size for street port and exaust ported engine???
02-19-02, 01:16 AM
#1
I am the Anti-Ch(rice)t
Thread Starter
Join Date: Nov 2001
Location: Savannah, GA
Posts: 1,363
Likes: 0
Received 0 Likes
on
0 Posts
injector size for street port and exaust ported engine???
well the thread title says it all, should i get larger injectors for my engine that i am going to street port and exh port???
Justin
Justin
02-19-02, 08:43 AM
#2
Rotary Enthusiast
Join Date: May 2001
Location: AL
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
The stock factory injectors will support up to 230HP at 80% duty cycle. Check out this site and learn more on sizing your injectors to your requirements and the engine requirements. Its a good factual site. Not a lot of fluff.
www.sdsefi.com
I can't remember exactly where the section on the injector sizing and capabilities are but its in there.
www.sdsefi.com
I can't remember exactly where the section on the injector sizing and capabilities are but its in there.
02-20-02, 07:02 AM
#5
Rotary Enthusiast
Join Date: May 2001
Location: AL
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
Sorry Ted if your talking to me. That would be for the 460cc injectors I'm referring to. I believe the TII injectors were good for about 320HP at 80%. These numbers are assuming the injectors have been professionally cleaned or brand new.
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM
