ok, i pulled my engine and im trying to seperate the housing and they are all stuck, what do i do?

 

get a Haynes or a Mazda shop manual.

 

oh c'mon i know half the people on this forum can do it, and i dont have 15$ to go get one..

 

i would definately go get a manual. You will also need a mallet to separate the housings. That is if you already took the tension bolts out.

 

Then spend a few minutes downloading the FSM section for the engine from www.fc3s.org ....

 

yea man u MUST get a manual. you rgonna be lost if that thing comes apart. check the bolts behind the flywheel!

 

Take off the clutch, flywheel, fan clutch mount pulley, front hub, front cover, oil pump, front counterweight, remove tension bolts (in the back of the engine under the flywheel), lay the engine vertically and smack it with a rubber mallet to separate the housings from the irons.

 

ohh thank you..