I need a cat-back...
#1
Rotary Freak
Thread Starter
Join Date: Feb 2001
Location: Okinawa, Japan
Posts: 2,149
Likes: 0
Received 0 Likes
on
0 Posts
I need a cat-back...
...to go with my brand spanking new RS*R frontpipe I got when I was in Japan. The cat back needs to be at least 3" I.D. all the way through. Most descriptions I see on web sites usually say that a pipe will start at 65mm then go to it's advertised size. Does anybody here know firsthand of any styles (I don't care which brand) that never go under 3". I know I could take one into a muffler shop and have them cut off the truncated inlet side and weld on a larger diameter pipe and matching flange, but that seems like work. :p Much thanks in advance.
jerk_racer@hotmail.com
jerk_racer@hotmail.com
#5
Best of both worlds
Join Date: Feb 2001
Location: NJ
Posts: 1,423
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need a cat-back...
Originally posted by Jerk_Racer
...to go with my brand spanking new RS*R frontpipe I got when I was in Japan. The cat back needs to be at least 3" I.D. all the way through. Most descriptions I see on web sites usually say that a pipe will start at 65mm then go to it's advertised size. Does anybody here know firsthand of any styles (I don't care which brand) that never go under 3". I know I could take one into a muffler shop and have them cut off the truncated inlet side and weld on a larger diameter pipe and matching flange, but that seems like work. :p Much thanks in advance.
jerk_racer@hotmail.com
...to go with my brand spanking new RS*R frontpipe I got when I was in Japan. The cat back needs to be at least 3" I.D. all the way through. Most descriptions I see on web sites usually say that a pipe will start at 65mm then go to it's advertised size. Does anybody here know firsthand of any styles (I don't care which brand) that never go under 3". I know I could take one into a muffler shop and have them cut off the truncated inlet side and weld on a larger diameter pipe and matching flange, but that seems like work. :p Much thanks in advance.
jerk_racer@hotmail.com
#6
Well I asked how big the inlet was from the Y-pipe and he said 3". The reason I had asked him was because he was selling the PE catback off a TII & wanted to know if it would bolt on an NA.
#7
Rotary Freak
Thread Starter
Join Date: Feb 2001
Location: Okinawa, Japan
Posts: 2,149
Likes: 0
Received 0 Likes
on
0 Posts
I forgot to mention that I just want a single pipe exiting either side. I was going to get the Apex'i GT until I found out that it was tapered down at the inlet. I think I'll just get this 80mm setup that's hanging from the ceiling in the shop I bought my frontpipe. It tapers down so I guess I'll have to take it to a muffler shop for them to do the welding. The hard part is getting my buddy to buy it and ship it to me from Japan. Oh well.
jerk_racer@hotmail.com
jerk_racer@hotmail.com
Thread
Thread Starter
Forum
Replies
Last Post
TurboFB
1st Generation Specific (1979-1985)
17
12-18-04 01:37 PM
Boosting_FC
2nd Generation Specific (1986-1992)
7
05-02-03 04:28 PM