ya i pulled my engine and striped it but i managed to break the rear housing getting the flywheel off. bent the bolt that is supposed to be a stopper and that bolt snaped off and then i put a bolt into antoher hole and the HOUSING snapped. does anyone know where i can get a new end housing piece. or if i send it to get it rebuilt can they do it? i dont know where to send it either. thanks guys

 

seiously this is a problem i meen i broke the ******* block man

 

Lol, how many miles does it have on it? Maybe you're due for a new one anyway

If it's just the "ear", could you weld it?

 

Try the forsale section of the forum.

 

Geez, 9 minutes before posts...

You can try and weld it or replace the housing.
Since replacing the housing requires the engine block to be opened up, I would recommend rebuilding the engine if you do open it up.

LOOK IN THE FOR SALE SECTION FOR PARTS.


-Ted

 

ya it has 120xxx ish miles on it. and i didnt really want to have to crack it open unless i need 2 so do u think if i sent it off they could rebuild it and replace the rear housing

 

Contact kevin over at www.rotaryresurrection.com see if he has the parts for the replacement. He's the best engine rebuilder at any price.

 

You're looking for a part for an Rx7 and you DIDN'T check the For Sale section..........?

 

120,000 miles on an NA (I'm assuming?) is low, so I would try and reweld it if possible.


-Ted

 

there is plently of NA irons on the FS section here, no T2 housings which is what i need though...

go look there.