a Autometer temp gauge, and a autometer airfuel gauge....worth doing it myself or just bring it to my shop? their going in a dual pillar, anyone have pics of the instalation or anything?

 

You need a few basic hand tools to finish the job. A tap and die and some JBWeild for the thermosensor, And removal of the IC to get to the O2 wire is about all you need.

Here is a very bad pic of how it's installed...

 

It's quite easy .

 

mine looks better

 

should you really be taking pictures while driving?

 

lol.

No.

 

SilverT2's was taken at idle - check the tach. I'm guessing he was stopped.

I have a temp gauge that I picked up, too. Where could I find one of them nifty pillar housings like in the pics? Is there a particular name for that style?

 

They are "a-pillar gauge pods." Can be bought at www.rx7store.net

 

Yes!! those are the best

http://www.bcrx7.com/modules/My_eGal...ent06/6-22.jpg

http://www.bcrx7.com/modules/My_eGal...ent06/6-23.jpg



a/f gauge is easy. water temp will be tricky. depends where you want to mount the sensor... mines in the water pump housing but you need to take it off to put it there (good 4-5 hours maybe?)

 

i guess ill just get it done since i have a temp as well and its gonna be a pain in the ***.

mike

 

Okay, just ordered one.

I've got an '86, but I assume that the 89-91 style will fit.

Thank you!

 

if you get the electrical guage do you just run the signal wire to the sender on the drivers side to the left of the oil filter?

 

Oh, and I'd like to install the sensor in the piece with the rad cap (filler neck? It's been a long day... ) Tool and die, right? I've never used them b4. Would someone give me a quick run-down on what I'll need and how to use it properly?