how much would it cost to have turbo sized flanges converted to NA?
05-29-11, 05:14 PM
#1
Full Member
Thread Starter
how much would it cost to have turbo sized flanges converted to NA?
I am wondering because I would like to get a presilencer that is made for turbos but I was told would work on NA's just fine, the only problem being the ID of the flanges. This is the presilencer http://www.racingbeat.com/RX7-1986-1...ms/16425P.html
Does anyone have any experience of having their flanges replaces or modified to a smaller size? 2.4 ID in this case. I am assuming the ID on the presilencer is 3 inches (80mm/3.1)
Does anyone have any experience of having their flanges replaces or modified to a smaller size? 2.4 ID in this case. I am assuming the ID on the presilencer is 3 inches (80mm/3.1)
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM