I need help i just droped this jspec motor with the harness from a running car! into my t2 and now theres no spark! i checked fuses, and some wires the car had spark before ! some people say it may be some ground wires! what should i do next??

thanks
shawn

 

ok do not install a gound wire to the coil first u might burn it up i know ppl that have done that. But the first thing is make sure you are geting a signal from the Crank angle sensor the manual says to check the R from the 2 left and 2 right ones and it should be from 110-210ohms. But this is what i would do i would get a test light and get a nedal and prong the the blue and white wire and c if it pulse and if it dose its good

 

What method are you using to check spark?