Has anybody measured their gas tank?
#1
Full Member
Thread Starter
Join Date: Aug 2001
Location: Burlington, VT
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Has anybody measured their gas tank?
I'm having fuel problems in my car... the lines are all rusted. I replaced them temporarily, but for a permanant solution I'd like to take the tank out and replace it with a fuel cell. Then I can replace the delivery and return lines with SS Braided hose.
Has anybody measured their fuel tank or put a fuel cell in the stock location? I'd like to start looking for the tank to get so when the snow melts I can put it in. (Yes, it's been snowing all weekend! )
Has anybody measured their fuel tank or put a fuel cell in the stock location? I'd like to start looking for the tank to get so when the snow melts I can put it in. (Yes, it's been snowing all weekend! )
#2
SOLD THE RX-7!
Join Date: Mar 2001
Location: Vancouver, BC, Canada
Posts: 7,451
Likes: 0
Received 0 Likes
on
0 Posts
I don't think you would get a very big fuel cell in there since they are square not custom fitted to the bottom of the car. to put a fuel cell in a 2nd gen you normaly cut out the floor of the truck and weld in some cross braces and have it sorta half in the truck and half below.
#3
Full Member
Thread Starter
Join Date: Aug 2001
Location: Burlington, VT
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! I was hoping for a different answer, but not expecting any wonderful news like "This part number fits perfect!"
It's not too bad to weld in a container for it. I had to do that for a CRX I built. This time I'm going to get a top drain cell though.
It's not too bad to weld in a container for it. I had to do that for a CRX I built. This time I'm going to get a top drain cell though.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM