need help im installing gauges where the ash tray or w/e the hell the thing is under the radio and im wondering where can i run the wires threw to get it into the engine compartment would i make a hole threw the bottom and run it under the car??? any suggestions would greatly help
Thanks In Advance
TwEaK

PICS ARE GOOD TO!

 

I went threw where the wiring harness is, right above the fuese box.

 

Yeah just go through an exsisting hole in the firewall. It may be easier to start from the engine bay and push it through, then pull it from inside.
-Ben

 

Yea if you drill another hole then you gotta make sure you don't hit anything, and you gotta buy little rubber things, its easier/faster to just put it into an existing hole.

 

lol rubber thingies dont believe in that its called electrical tape haha =P ok ill try that out see how it goes my only problem is i cant take out the fram the center console fram for the radio
TwEaK

 

You cant take out the stereo surround? Why not? It's so easy. Take off the shifter surround, take out the ashtray. Take out the center vents and then unscrew 2 screws underneath the vents. and I think 4 or 6 other screws. Take out the cigarette lighter also. Pull off the surround.

 

Man those rubber things are so the wire doesn't rub against the sharp hole you drilled in the firewall and slowly cut into the wire, eventually grounding it. **** I saw it on some show, it looked like it made sense .

 

They are called gommets.

 

Grommets!! Thats the word I was looking for! Thanks man!

 

i cant get it to work poop! pics would help!!!!
TwEaK

 

You mean the wire won't fit? What spot are you trying to run it though? Try the one Cowzzz said (wiring harness, right above fuse box). Good luck!