Fresh rebuild, slowly looses coolant pressure
#1
Full Member
Thread Starter
Fresh rebuild, slowly looses coolant pressure
I just finished my rebuild last night and got back to it today to pressure test the motor and after about 30 minutes it drops from 15 psi to 9 psi. Do I just need to go ahead pull the motor back apart for a possible pinched seal or is there some things I should check before I do that?
update: one of my housing freeze plugs i just installed was leaking a little bit so hopefully it’s just that
update: one of my housing freeze plugs i just installed was leaking a little bit so hopefully it’s just that
Last edited by kudu; 04-03-22 at 03:43 PM.
#2
I just finished my rebuild last night and got back to it today to pressure test the motor and after about 30 minutes it drops from 15 psi to 9 psi. Do I just need to go ahead pull the motor back apart for a possible pinched seal or is there some things I should check before I do that?
update: one of my housing freeze plugs i just installed was leaking a little bit so hopefully it’s just that
update: one of my housing freeze plugs i just installed was leaking a little bit so hopefully it’s just that
#3
Full Member
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
badass7
3rd Generation Specific (1993-2002)
0
03-20-02 12:44 PM