2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Flooding!! Pls help!!

Thread Tools
 
Search this Thread
 
Old 10-22-10, 07:02 PM
  #1  
Junior Member
Thread Starter
 
neilan21's Avatar
 
Join Date: Jun 2010
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
WA Flooding!! Pls help!!

okay so i have an 86 n/a. no extras or anything on it completely stock. and it seems to be flooding allll the time. especially in the mornings. i have to do the fuse pull thing sometimes 5-10 times while jumping the battery. and when i do get it started it smokes white smoke pretty badly. but there are sometimes when i only have to fuse pull once and then it starts up completely clean after with no smoke. so idk if it was flooded or something else. it especially seems to not start in the mornings when its cold out. i would really really like to know how to fix the flooding problem. one thing i wanna do whether i fix the flooding or not is fix up a switch to the cabin that cuts off the fuel pump so i can just switch it off and let the engine run itself out of gas so it wont flood. how would i go about doing this and what exactly would i need to do this? anything you guys have would help me greatly. thanks
Old 10-22-10, 08:35 PM
  #2  
Retired Moderator, RIP

iTrader: (142)
 
misterstyx69's Avatar
 
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes on 114 Posts
Check your Water temp sensor on the back of the waterpump to see if it is hooked up.If that part goes "wonky; then it can cause flooding.
But honestly I think your injectors should be serviced.Dirty injectors is the main cause of Flooding/no start...That and Low compression.
I'd tell you where I put a Fuel kill on my car but I alot of People wouldn't say it's not the best solution...But hey,it works every time and I don't look like an **** popping the hood and pulling fuses!.I'm just one Dumb Wankel!
Old 10-23-10, 11:08 AM
  #3  
Junior Member
Thread Starter
 
neilan21's Avatar
 
Join Date: Jun 2010
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
Okay but if it was the Injectors the engine would be flooded with gas. So when I got the car started wouldn't it smoke black? Not white? Idk this is just what I've been told by a few people. But imma get my injectors cleaned and whatnot to see if that helps. And I'm puttin in a cutoff switch too just because. I guess we will see what happens. My car is just a piece of trash. So much is wrong with that thing it's ridiculous. But thanks for the advice!
Old 10-23-10, 11:31 AM
  #4  
Junior Member
Thread Starter
 
neilan21's Avatar
 
Join Date: Jun 2010
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
Also how many wires are supposed to be hooked up to the fuel pump? And which one is the one that I need to hook the switch up to?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
tidanb0utch
2nd Generation Specific (1986-1992)
11
10-07-15 07:36 AM
PinkRacer
2nd Generation Specific (1986-1992)
43
10-01-15 09:13 AM
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM



Quick Reply: Flooding!! Pls help!!



All times are GMT -5. The time now is 10:58 AM.