i just recently bought a 87 turbo II and i am have feul prob and i am wanting to replace the injector with stock replacement and was wonder if there is a diff in the pri and sec injectors


also want to replace the pulsation damper, was wonder where i could find one for a good price


thanks

 

The injectors are the same, the PD if being replaced is best bought new from Mazda.

 

What fuel probelms are you having? Why do you think it's the injecotrs? Diagnose the cause of the problem before spending money unnecessarily.

 

http://www.trademotion.com/partlocat...?siteid=214264

Try there.

 

i am gettin way to much feul to the cyc and it has a raw fuel smell reall bad and is also running real crapy. i have replaced the fuel press reg, tested the pump, afm, i did i pressure check on the pump and it is good. i did a pressure check on the fuel sys and it will not hold pressure. the pressure goes up to about 42psi when i turn the pump on and then leaks straight down to 0 psi. so it sounds like i have an injector stuck open

 

You can leak test the injectors by following the instructions in the FSM Fuel systems chapter. Once you have them out you'll probably be able to tell if one's stuck open just by blowing through them.

If you don't have the FSM (Factory Service Manual), click here and download it in PDF format for free.

 

Before I bought new, I would send the old ones to RC Engineering to be rebuilt. If they are shot, they will tell you.
www.rceng.com

 

www.witchhunter.com does the same thing, and are cheaper.

 

http://www.overnightautoparts.com/st...u&make_code=MA

i found these injector and i was wonder u guys think they will fine. i just need the car to run for now and then i am going to later on get a bigger turbo and injectors but for now i just need it to run right

 

anyone?

 

it looks good to me. As long as they are stock replacement.