2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Engine cuts out when cold

Thread Tools
 
Search this Thread
 
Old 12-02-04, 01:09 AM
  #1  
Lets rock.

Thread Starter
 
flamin-roids's Avatar
 
Join Date: Apr 2004
Location: SLC, Utah
Posts: 1,355
Likes: 0
Received 0 Likes on 0 Posts
Engine cuts out when cold

Ok the problem: When the car is cold and I rev it up (anywhere between 3k-4k rpm) it cuts out like its dying. But doesn't completly die. It will do this about 2 or 3 times till the check engine light comes on. Once the light comes its fine and will not hesitate again until the car is cold. The car runs fantastic also. Here's what might of happened: Recently my water pump started leaking. But it was a slow leak and I needed to take the car to work. Antifreeze is too expensive to waste and the weather was good enough to where it won't freeze. Anyways the night before I got my water pump it went from 50's to 10's and froze my **** right up. I thawed out my system, installed the water pump, and refilled with 50/50 antifreeze. Took a bit to thaw it out completly but I watched the temps. Now there is no coolant leaking whatsoever. Temps are fine and for some reason I'm idleing at 1500rpm once the check engine light comes on. What could it be? I know for a fact it was something coolant related. Possibly thermowax?
Old 12-02-04, 01:12 AM
  #2  
Super Raterhater

iTrader: (6)
 
SonicRaT's Avatar
 
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,624
Likes: 0
Received 2 Likes on 2 Posts
Very likely that the thermowax isn't releasing, what error code comes on?
Old 12-02-04, 01:21 AM
  #3  
Lets rock.

Thread Starter
 
flamin-roids's Avatar
 
Join Date: Apr 2004
Location: SLC, Utah
Posts: 1,355
Likes: 0
Received 0 Likes on 0 Posts
I haven't checked yet. The check engine light does flash a few times when it cuts out.
Old 12-02-04, 01:53 AM
  #4  
Rotary Enthusiast

 
rs_1101's Avatar
 
Join Date: May 2004
Location: OC
Posts: 1,088
Likes: 0
Received 0 Likes on 0 Posts
what do you mean it cuts out.. like the sound of one rotor type of cutting out?
Old 12-02-04, 02:02 AM
  #5  
Lets rock.

Thread Starter
 
flamin-roids's Avatar
 
Join Date: Apr 2004
Location: SLC, Utah
Posts: 1,355
Likes: 0
Received 0 Likes on 0 Posts
Like running out of gas cutting out.
Old 12-02-04, 02:05 AM
  #6  
Super Raterhater

iTrader: (6)
 
SonicRaT's Avatar
 
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,624
Likes: 0
Received 2 Likes on 2 Posts
It's very likely you killed the water thermo sensor, check the damn code!
Old 12-02-04, 03:35 AM
  #7  
Rotary Enthusiast

 
rs_1101's Avatar
 
Join Date: May 2004
Location: OC
Posts: 1,088
Likes: 0
Received 0 Likes on 0 Posts
well.. when my cars cold, sometimes it feels like its running on one rotor. which is pretty unmistakeable. it sounds like your car running at half the rpms it should be.
Old 12-02-04, 03:59 AM
  #8  
Lets rock.

Thread Starter
 
flamin-roids's Avatar
 
Join Date: Apr 2004
Location: SLC, Utah
Posts: 1,355
Likes: 0
Received 0 Likes on 0 Posts
No it completely cuts out. No rotors. Ever ran out of gas and it stutters. ITs like that.
Old 12-02-04, 03:27 PM
  #9  
Super Raterhater

iTrader: (6)
 
SonicRaT's Avatar
 
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,624
Likes: 0
Received 2 Likes on 2 Posts
Hrm... Sounds like my car, except mines got a bad coolant seal so it steam cleans itself on startup, does yours do it after sitting for about 5-10 minutes (after its warmed up and driven, and you attempt to restart it) Have you checked for bubbles/etc?
Old 12-02-04, 05:19 PM
  #10  
Lets rock.

Thread Starter
 
flamin-roids's Avatar
 
Join Date: Apr 2004
Location: SLC, Utah
Posts: 1,355
Likes: 0
Received 0 Likes on 0 Posts
No steam. No leaks anywhere. And its fine as long as the car hasn't completely cooled down (4 hours) The cutting out only happens a couple of times. The check engine light comes on. And the car is fine.
Old 12-02-04, 05:21 PM
  #11  
Super Raterhater

iTrader: (6)
 
SonicRaT's Avatar
 
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,624
Likes: 0
Received 2 Likes on 2 Posts
Well then, check the code, probably the water thermo sensor.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
elfking
3rd Generation Specific (1993-2002)
3
08-19-15 09:48 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM
Wolf_
Single Turbo RX-7's
3
08-11-15 04:23 PM



Quick Reply: Engine cuts out when cold



All times are GMT -5. The time now is 12:15 AM.