RX710thAE

my e-brake light wont turn off!!! I'm like wtf?! this happened like 3 days ago and I dont know what happened. Could it be from my turbo timer? I have a Greddy one...but I've had this Turbo timer installed for quite a while....maybe loose wiring?

t90man

make sure your ebrake is all the way down and the sensor button by the lever isn't sticking, if the little button at the handle is down it triggers the light to go on

Icemark

low brake fluid

the.white.fc3s

maybe you drift too much, LOL

90FC

yeah, it's low brake fluid it happened to me.

Cosmo_TT

iTrader: (11)

not always brake fluid when i got mine running again it was on for a week or two but then i noticed it off so it must have been a sticky switch

Sgt. Pepper

My e-brake light used to light up on my warning cluster when I took sharp turns, but as of late the light stays on even if i'm just sitting there with the e-brake as far down as it will go. It will just go away after a few minutes. What could be causing this? I read low brake fluid, is that it? Could it be some kind of error code of some sort, or is my e-brake cable too lose?

snowball

sounds like low brake fluid.

Snack

low brake fluid... lol tricks everyone one in their lives

nukeall

while were discussing e brake ..... how do i tightend mines???????? 88 gtu s4 thanxs

NZConvertible

LOW BRAKE FLUID!

Since you dug this up from several weeks ago I assume you actually read it...

nukeall

but how do you ajust the e brake ????

Sgt. Pepper

I did, just wanted to make sure since the thread creator said his light never turns off, while mine does after a few minuts. I thought it could have been a loose e-brake cable or something.

dot_txt

iTrader: (1)

low fluid.. or your breaks are worn way down.

nukeall

dude do i have to make a new thread to get someone to tell me how to adjust my e brake ?

Icemark

That is covered in the factory shop manuals. Links for factory shop manuals can be found in the FAQ for FC sticky thread found at the top of this, the 2nd gen RX-7 Technical section.

You can do minor adjustments by removing the hand brake cover and turning the adjustment nut there.