Differential removal problems
#1
Junior Member
Thread Starter
Join Date: Sep 2007
Location: Atlanta, GA
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Differential removal problems
So following along with the directions i've got...
Raise car, done
Drain diff lub, done
Unbolt driveshaft, done
Disconnect driveaxles, done
Remove differential front mounting nuts, hmmm
There appears to be 3 nuts I need to remove. 1 wasn't so bad, 1 was pretty annoying but eventually got, and now the 3rd looks impossible to get to without lowering the subframe. Am I looking at this wrong? Here's the bolt that I can't get to.
Raise car, done
Drain diff lub, done
Unbolt driveshaft, done
Disconnect driveaxles, done
Remove differential front mounting nuts, hmmm
There appears to be 3 nuts I need to remove. 1 wasn't so bad, 1 was pretty annoying but eventually got, and now the 3rd looks impossible to get to without lowering the subframe. Am I looking at this wrong? Here's the bolt that I can't get to.
#4
Rotary Enthusiast
Join Date: Feb 2005
Location: Norway
Posts: 846
Likes: 0
Received 0 Likes
on
0 Posts
Does the Haynes manual tell you to remove THOSE three bolts?
I always remove the two on the other side of the mount! Let the subframe down 1-2" (or all the way down) and you`ll get to the two i mean really easy!
I always remove the two on the other side of the mount! Let the subframe down 1-2" (or all the way down) and you`ll get to the two i mean really easy!
Trending Topics
#8
If you drop the subframe to the point where the front mounting point nuts are flush with the lower end of the mounting bolts you should have enough room to get to the diff bolts and get the diff out. Dropping the whole rear subframe is a PITA...don't drop it all the way if you can avoid it.
(oops...just saw that you ended up dropping it all the way...)
(oops...just saw that you ended up dropping it all the way...)
Thread
Thread Starter
Forum
Replies
Last Post
tiger18
3rd Generation Specific (1993-2002)
9
09-03-15 08:27 PM